Outcamp RJ45 Ethernet Wall Socket for Starlink Gen 3 | IP68

Add a sealed Ethernet outlet to your Starlink Gen 3 setup

Run a permanent Ethernet connection through a caravan wall, canopy, truck body or equipment enclosure without leaving a cable dangling through a window or door seal. This machined aluminium panel gives you a shielded RJ45 socket on the outside and a clean termination inside, so your Starlink Gen 3 cable run stays weatherproof in transit and on site.

Key features

• IP68 sealed: hinged cover, silicone O-ring and sealing washer keep water and dust out, so the panel suits permanent outdoor mounting on a vehicle or trailer.
• Shielded CAT6 pass-through: RJ45 female connector at both ends, letting you use any standard CAT6 patch or bulkhead cable at whatever length you need.
• Machined aluminium body: UV and corrosion resistant, and considerably more durable than plastic alternatives in outback heat and dust.
• Two mounting options: surface-mount onto a flat panel with the four supplied screws, or flush-mount through a 25 mm hole using the aluminium locking nut.
• Complete hardware kit: four stainless steel screws, two mounting washers and a silicone O-ring are included, so there is nothing extra to source.

Specifications

Installation and care

Drill a 25 mm hole for flush mounting, or simply screw the faceplate to a flat surface. Feed your CAT6 cable through, terminate both ends, then seat the O-ring before tightening. Keep the hinged cover closed whenever a cable is not connected, and wipe the seal with a damp cloth rather than a solvent to protect the rubber.

Shipping and returns

Dispatched from South Australia. Orders placed before 12pm ACST on a business day are usually sent the same day, with tracking emailed on dispatch. Faulty items are covered by our returns policy.